The following instructions are prepared for those who wish to completely wipe their DTVS-SMART1 and reload all the software. This process can also be used to recover the DTVS-SMART1 from serious software failure to improper shutdown or rouge software corrupting the units memory. If your machine does not start up after a very long period, then it is possible that the units has corrupt software or memory. Carry out the following to recover your unit:
** NOTE: USE THIS PROCEDURE FOR SOFTWARE VERSION BELOW 1.5.6 **
1. Download software version 1.4.9 via the following link:
https://drive.google.com/open?id=11ZvqQeaPsJKuxwzxBXbm6XKFA8sqedzH2. Extract the file "NTOBE-S_UPGRADE.BIN" to the root directory of a USB memory key
3. Shut down the DTVS-SMART1 and then insert the USB key into the USB1 slot (at the back). Please ensure no other USB devices are attached.
4. Start the DTVS-SMART1 and then immediately press the RED button until the "Recovery Menu" appears.
5. Select Option 3 and then Option 3 again and the 1 (yes) to clear all partitions
6. The receiver will restart and begin loading software version 1.4.9
7. Software version 1.4.9 will allow your receiver to be recovered to a working state. You will then need to upgrade to the latest software version
8. Download the latest software version from the DTV Solutions forum
9. Extract the file "NTOBE-S_UPGRADE.BIN" to the root directory of a USB memory key replacing any other version
10. Shut down the DTVS-SMART1 and then insert the USB key into the USB1 slot (at the back). Please ensure no other USB devices are attached.
11. Start the DTVS-SMART1 and then immediately press the BLUE button until the "upgrade.." message appears.
12. Allow the upgrade to proceed
13. Once upgraded, press MENU and then go SYSTEM and select "Factory Reset"
14. Your receiver will now start up and will show the Initial Setup Menu. Carry out the installation as normal.
15. Load other Android applications needed via "DefaultApps" application
